Grass Valley DD10 part 1 - Manual (Page 18)

2.3 DVE Panel Diamond digital DD10
12
2.3.1 NOTES TO DVE CONTROL
Connection Pleas refer to installation manual.
Operating modes DVE devices that are linked to the Diamond digital switchers in terms of signals and
control can be used in various modes.
1. FX Loop
In this mode, the video and key signals to the DVE device are switched automat-
ically and the sequences of the DVE device are controlled with the fader in the
Transition panel. The DVE device permits transitions of the background and of
keyers that are controlled in the same way as wipe transitions.
In this mode, Loop and DVE transition are enabled.
2. FX Loop without fader
In this mode, the video and key signals to the DVE device are switched manu-
ally. The control of the sequences is made with the DVE digipot in the Wipe
panel, which in this mode is switched over to DVE operation.
This mode permits integrating particularly static DVE effects into a picture, e.g.
smaller pictures at a fixed position.
In this mode, Loop is enabled and DVE transition is disabled.
3. DVE effects without FX Loop
In this mode, all signals applied to the switcher as well as the internal signals
from the key levels may be selected as DVE input signals. The DVE sequence
control is made with the DVE digipot in the Wipe panel, which in this mode is
switched over to DVE operation. The DVE effect is faded-in at any key level of
the switcher.
In this mode, Loop and DVE transition are disabled.
4. In modes 2 and 3, the DVE device may also be directly controlled by an external
editor instead of the digipot. For this no control link exists between switcher and
DVE.
Effect selection After Remote has been enabled in the DVE, the desired DVE sequence is selected
with the wipe effect keys in the Wipe panel of the switcher. DD5 and DD10 are
switched over to DVE operation by disabling the functions (keys) Wipe1, Wipe2 or
Mask. Below one of the digipots DVE is displayed.
The wipe keys of a DD20 switcher correspond to the DVE snapshot numbers 1-15
or, when the 2nd key is actuated, to the snapshots 16 - 30.
The DD5 switcher features less keys for the wipe or sequence selection.
The selectable sequence numbers are as follows:
1. bank 1 - 4 2. bank 6- 9 3. bank 11 - 14
with the 2nd key
1. bank 16 - 19 2. bank 21 - 24 3. bank 26 - 29