Grass Valley DD10 part 1 - Manual (Page 26)

2.4 Transition Panel Diamond digital DD10
20
Fader The fader enables sensitive manual transitions. The yellow arrows to the left of the
fader show the moving direction to the next contribution which is shown on the pre-
view monitor.
Cut Cut causes an instantaneous transition (hard cut).
Auto Auto performs the transition as a fade with the preset transition rate. The key will
light for the duration of the transition and the selected transition rate is shown in the
associated display.
The transition can be immediately completed by pressing Cut or be manually fin-
ished with the fader.
In the same way, it is possible to halt the automatic transition by pressing Auto
again and to continue by pressing it once more.
Trans dur The function Trans duration enables selection of a transition duration within 1 and
9999 frames.
Adjustment:
•
Press Trans dur. After actuation, Trans dur and and the keys of the numeric
keypad on the EXTRA panel will light and request entry of the rate.
•
Enter the desired transition rate with the numeric keypad.
For checking, the entry is shown in the display.
Faulty entries can be deleted by pressing Clr.
•
After entry, press Enter.
•
If Trans dur has been erroneously pressed, press it again to deselect the func-
tion.
Key 1, Key 2 If the keyers have to be switched on or off without using the next transition function,
select the corresponding key stages with Key 1 or Key 2 on the Keyers panel and
perform a hard cut with Cut on the Keyers panel.