Grass Valley Aurora Edit LD v.6.0a Installation - Manual (Page 43)

Installing SDR and HDR Boards Into the Computer
Aurora Edit Installation and Configuration Guide 43
Cabling the HDR Board to the HDR Breakout Box
The HDR and SDR Breakout Box and their corresponding cards have different
cable attachments.
To connect an HDR board to an HDR Breakout Box:
1. Using the connector cable provided with the Breakout Box:
a. Attach the 60-pin plug to the Breakout Box back panel.
b. Attach the other cable end to the 60-pin plug on the board endplate.
2. Using the three BNC connectors (labeled SDI IN, SDI OUT 1, and SDI
OUT 2):
a. Attach the plugs to the Breakout Box back panel.
b. Attach the other cable end to the BNC connectors on the board endplate.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
The class A digital apparatus complies with Canadian ICES-003. Cet appareil numerique de la classe A est conforme a la norme NMB-003 du Canada.
( ( KBox
SDI IN
CONNECT TO HOST
SDI OUT 1 SDI OUT 2 J1
BNC Connectors
Align slots in cable
connector barrel with
connector pins.
Slide barrel over pins and
rotate barrel to lock
connectors together.
Pin
Barrel
SDI OUT 1
SDI OUT 2
SDI IN