Grass Valley Aurora Edit LD v.6.0a Installation - Manual (Page 34)

Chapter 2 Setting Up the Hardware
34 Aurora Edit Installation and Configuration Guide
Ethernet Connection
If you are using a Network Attached Storage (NAS) system, you are using a
Gigabit ethernet connection.
To connect an ethernet switch to the Aurora Edit workstation:
• Plug the end of the RJ45 cable into the Gigabit port on the back of the Aurora
Edit workstation and the other end into your ethernet switch.
Fibre Channel Connection
If you are using a Profile Media Server as part of your Aurora Edit system, or
creating a shared storage system with an Open SAN network, you are using
fibre channel connections. You may have a single- or dual-port fibre channel
board.
To connect a fibre channel switch to the Aurora Edit workstation:
• Plug the ends of the network cable into the TX and RX connectors on the back
of the Aurora Edit workstation and the other ends into your fibre channel
switch.