H3C Technologies H3C S12500 Series Switches - Manual (Page 97)

87
Replacing a transceiver module
Replacing the XFP, SFP+, SFP, and QSFP+ modules
CAUTION:
Do not touch the golden finger of a transceiver module during replacement.
The replacement procedures for the XFP, SFP, SFP+, and QSFP+ modules are similar. This section uses an
SFP+ module as an example.
To replace a transceiver module:
1. Put on an ESD wrist strap, making sure that the strap makes good skin contact and is correctly
grounded.
2. Remove the optical fibers from the SFP+ module, pivot the clasp down to the horizontal position,
and then pull the SFP+ module out of the port, as shown in
Figure 74 .
Figure 74 Removing the SFP+ module
3. Put the removed SFP+ module in an antistatic bag or its original shipping materials.
4. Unpack the SFP+ module to be installed and make sure the clasp is closed.
5. Remove the optical fiber, if any, from the SFP+ module before installing it.
6. Gently insert the SFP+ module into the port until it fits in completely, as shown in Figure 75 .
7. Connect the optical fibers to the new SFP+ module.