Replacement procedures, Cleaning the air filters, Cleaning the chassis air filters – H3C Technologies H3C S12500 Series Switches User Manual
Page 84: For an s12508
74
Replacement procedures
IMPORTANT:
Place a removed module in an antistatic bag or its original shipping materials.
Cleaning the air filters
The air filters of an S12500 switch fall into the following types:
•
Chassis air filter—No chassis air filter is shipped with the S12500 chassis by default. You can order
one as needed.
•
Power supply air filter—An S12500 chassis is installed with a power supply air filter when shipped
by default.
To guarantee good ventilation of the switch and power supplies, H3C recommends that you clear the air
filters monthly. You must clean the air filter every three months at least.
Cleaning the chassis air filters
For an S12508
1.
Holding the notches of the front plastic panel at the bottom part of the chassis, and gently pull the
plastic panel out.
2.
Loosen the screws that fix the chassis air filter to the rear of the plastic panel, and remove the
chassis air filter from the plastic panel.
3.
Use clean water to wash the chassis air filter, and air-dry it.
4.
Install the chassis air filter to the correct position. For more information, see "