H3C Technologies H3C S12500 Series Switches - Manual (Page 62)

52
Figure 52 LC fiber connector
Figure 53 MPO fiber connector
3. Connect one end of the fiber to the SFP module of the S12500 switch.
4. Connect the other end of the fiber to the peer device.
Connecting an SFP+ cable and a QSFP+ cable (optional)
The installation of the SFP+ cable and QSFP+ cable is similar. This section uses an SFP+ cable as an
example.
NOTE:
•
SFP+ cables are hot swappable.
• When connecting an SFP+ cable, make sure the bend radius of the cable is no less than eight times of
the diameter of the cable.
To connect an SFP+ cable:
1. Wear an ESD wrist strap and make sure the strap has a good skin contact and is correctly
grounded.
2. Unpack the SFP+ cable.
3. Insert one end of the plug of the SFP+ cable horizontally into the SFP+ slot on the switch and the
other end of the plug into the SFP+ slot of the peer device.
LC plug
SFP module
MPO plug
QSFP+ module