Status and diagnostic indicators, Firmware versions and their functions – Wavetronix Click 342 (lean managed ethernet switch) (CLK-342) - Managed Switches User Guide User Manual
Page 9
8
CHAPTER 1 • CLICK 340/341/342 MANAGED SWITCHES
Figure 1.3 – Housing Dimensions of the Managed Switch in Millimeters (Inches)
Status and Diagnostic Indicators
The table below shows the status of both the supply voltage and Ethernet port LEDs (see
Table 1.1).
Des.
Color
Status
Meaning
US1
Green
ON
Supply voltage US1 in the tolerance range
OFF
Supply voltage US1 less than 18 V DC
US2
Green
ON
Supply voltage US2 in the tolerance range
OFF
Supply voltage US2 less than 18 V DC
LNK
Green
ON
Link active
OFF
Link not active
Flashing
Transmitting/receiving
100
Yellow
ON
Full duplex mode
OFF
Half duplex mode
Flashing
Collision detected
Table 1.1 – Status and Diagnostic Indicators
Firmware Versions and Their Functions
For the Click 340/341/342, firmware version 1.04 provides the standard switch functions.
Firmware 3 offers the following additional functions:
˽
Multicast filter mechanisms