Wavetronix Click 342 (lean managed ethernet switch) (CLK-342) - Managed Switches User Guide - Manual (Page 32)

CHAPTER 4 • WEB-BASED MANAGEMENT 31
SNMP Configuration Menu
The SNMP Configuration menu is used to display or modify user-specific device data, e.g.,
location, device name or function (see Figure 4.6).
Figure 4.6 – SNMP Configuration Web Page
The Trap Configuration part of the table is used to view or modify the IP addresses of the
two trap receivers. It is also used to activate/deactivate the Send traps function.
Software Update Menu
The Software Update menu is used to view or modify the parameters for a software update
and to trigger the update (see Figure 4.7).
Figure 4.7 – Software Update Web Page
Executing the Firmware/Software Update
The device must have valid IP parameters so that the firmware can be updated. You also
need a functional TFTP server.
The following steps are required to update the software (see Figure 4.8):
1 Save the selected firmware/software in the download directory of your TFTP server.
2 Start the TFTP server.
3 Start the WBM of the switch and call the Software Update page (General Configura-
tion/Software Update).
4 Enter the IP address of the TFTP Server in the TFTP Server IP Address field.