Sundance SMT310Q - Manual (Page 50)

Version 2.1 Page 50 of 55 SMT310Q User Manual
Pin1
After the JTAG cable has been connected the user should run impact. Once the
connection has been detected and setup Impact will show that there are two different
CPLDs.
The first EPLD (XC95144XL) in the chain needs to be loaded with the file ‘pciarb.jed’.
For the second EPLD (XC95288XL) the user will want to load the file ‘comm.jed’.
After the CPLDs have been programmed, you have to run the SetCpld.exe utility
contained in the package. This utility is run from a command line, and will change
the CPLD version number stored on the carrier board. This version information is