1 cplds updating, 1 cpld and eprom reprogramming – Sundance SMT310Q User Manual
Page 49
Version 2.1
Page 49 of 55
SMT310Q User Manual
•
to the header J21 of the
SMT310Q as shown in the table above.
•
for the update (configuration files and an executable).
15.1
CPLD and EPROM reprogramming
It is possible for the CPLDs or EPROM’s data files on the SMT310Q to become
corrupt. This section helps to solve such issues. Users may also want to change the
CPLDs’ code to implement their own protocol. For this the use must fully understand
how the JTAG connection works and what steps are needed to program the CPLD.
The EPROM generally only uses the code supplied by Sundance but as it can
become corrupted therefore the user must have a way to update its content.
The files and the instructions for the update of the CPLDs are described in the
.
15.1.1 CPLDs updating
The EPLDs can be accessed through the
. To access the
EPLDs you will need both the Xilinx parallel programming cable and a copy of the
ISE version 6.3 or later. The earlier versions of impact don’t support the type of
EPLDS on board the SMT310Q.