2 control register (bar1, offset 1416, write-only), Control register (bar1, offset 14, Write-only) – Sundance SMT310Q User Manual
Page 17: 2 control register (bar1, offset 14
Version 2.1
Page 17 of 55
SMT310Q User Manual
4.3.2 Control Register (BAR1, Offset 14
16
, WRITE-ONLY)
The CONTROL register contains various control flags:
7-4
3
2
1
0
IIOF2
IIFO1
IIOF0
RESET
RESET
Write a 1 to this bit to assert the reset signal to all the TIM modules on
the SMT310Q.
IIOF0
IIOF1
IIOF2
These bits connect to the corresponding pins on the TIM in module site
1. Writing 0 causes the corresponding IIOF line to go low.
Table 3: Control Register
Note. On PCI system reset, RESET is asserted to all TIM sites.
This manual is related to the following products: