Scotsman CME506R AutoIQ - Manual (Page 4)

Location:
A 6 inch minimum clearance on the back, left and
right sides is required for the proper operation and
service of this machine.
Locate the condenser as near as possible to the
interior location of the ice maker.
Select the best available location, one that protects
the condenser from extremes of dust, grease and
sun.
Meet all applicable building codes.
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove
the carton, and using part of the carton as a
cushion, tip the bin on its back to remove the skid
and attach the legs or casters. Note: Stacked
applications may not use casters.
Return the bin to an upright position. Check the bin
top gasket for gaps and tears, fill any in with food
grade sealant prior to placing the ice machine on
the bin.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Lift the ice
machine off the skid directly onto the bin.
Secure the ice machine to the bin with the
hardware provided (two metal straps and 4 bolts).
After all packing materials have been removed
from the ice machine, lift or hoist the machine onto
the bin. Align the sides and back of the machine
with the sides and back of the bin. Secure the ice
machine to the bin with the two metal straps and 4
bolts provided.
Cabinet Panel Removal:
Note: The top panel holds the upper edges of the
side panels in place.
1. Front Panel, “A” series: Remove the front
panel by removing the four screws connecting the
front panel to the left and right sides.
Front Panel “C and D” Series: Remove top two
screws and pull the bottom of the panel away from
the machine to unsnap it from the machine.
2. Lift up at the front edge and pull the top panel
forward until it releases from the tabs connecting it
to the back panel.
3. Remove two screws at the front of each side
panel, and pull them forward until they release
from the tabs connecting them to the back panel.
CME506R, 656R, 806R: AutoIQ Cubers
January 2000
Page 4
Remove
Second
Remove
First
Panel Removal