Scotsman CME506R AutoIQ - Manual (Page 37)

Removal and Replacement: AutoIQ Controller
1. Disconnect the electrical power.
2. Remove the front panel.
3. Remove mounting screw holding controller to
cabinet.
4. Touch a metal surface to discharge any static
electricity.
5. Pull controller out slightly and unplug all
electrical connections.
Note: Do NOT touch the back of the controller.
6. Carefully remove the new controller from its
packaging. Again, do NOT touch the back of the
controller.
7. Plug all electrical connectors into the new
controller.
8. Re-attach the controller to the cabinet.
9. Switch on the electrical power. All LEDs should
lite up.
10. Push and release the Freeze button.
11. Replace the front panel.
Electric Eyes (Bin Control)
These must be replaced as a set.
1. Remove front panel.
2. Push and release the Off button.
3. Remove top panel.
4. Remove left and right side panels.
5. Unplug both from the Controller (#3 and #4).
6. Remove evaporator cover.
7. Remove cube deflector.
8. Push in at the wire inlets the bin controls.
9. Pull both into the freezing compartment. Pull
wires thru the holes.
10. Remove both bin controls from the freezing
compartment.
11. Reverse to reassemble.
CME506R, 656R, 806R: AutoIQ Cubers
January 2000
Page 37
1
2
3
4
5
6
7
8 9
Reservoir Water
Level Sensor
Bin Control Sensor
Bin Control Sensor
Reservoir & Discharge
Line Thermistors
Low Voltage In/out
Water Valve
Hot Gas Valve
Contactor Coil
Stacking
Hi Voltage In/out
Water Pump
Air Cooled Fan Motor