Orion System PT-Link II BACnet3 - Manual (Page 17)

PT-Link II BACnet3 Interface
4. UPDATING THE SOFTWARE
17
4.1 Updating the PT-Link II Controller
13.) The Application ID should be SS1035 and the Application Version
should match the software version you will be updating to.
14.) In the HEX File fi eld, enter the path and name of the HEX fi le you
downloaded and/or copied to your hard drive. Use the Browse button
(...) to the right of the fi eld if you need help in locating the fi le.
15.) Now, cycle power to the PT-Link II once again and within 5
seconds click on the
button (shown above). If suc-
cessful, you should see the Progress Application HEX bar showing the
progress percentage.
16.) When the bar shows 100% completed, verify the PT-Link II’s
software is running by observing the Timer LED blinking.
17.) Verify the PT-Link II’s Application Version by once again cycling
power to the PT-Link II and within 5 seconds clicking the
button.
18.) Verify all fi elds are correct in the information below the
Info>
button and under “Finalization Data.” The “Int Flash Length”
and “Checksum” values should match the values provided with the
software sheet.