Orion System PT-Link II BACnet3 - Manual (Page 12)

Zone
Zone
3. PT-LINK CONFIGURATION
PT-Link II BACnet3 Interface 12
3.3 IP Address Confi guration
Figure 10: BACnet MS/TP Settings for Node_Offset
3.3.2 BACnet MS/TP - Setting Node_
Offset to Assign Specifi c Device
Instances
After setting your PC to be on the same subnet as the PT-Link,
open a web browser on your PC and enter the IP address of
the PT-Link; the default address is 192.168.1.24. (Figure 10).
1. If the IP address of the PT-Link has been changed by previous
confi guration, you will need to get the assigned IP address from the
network administrator or use the FieldServer ToolBox to fi nd the
IP Address.
2. The confi guration page will be displayed as your landing page.
(Figure 10)
3. The node offset can be changed on the confi guration page.
4. The Node_Offset fi eld will be presented displaying the current
value (default = 50,000).
5. Change the value of Node_Offset to establish the desired Device
Instance value, and click .
Device Instance = Node_Offset +
A bank DIP switch setting
(A1-A7)