OpenEye CM-512 - Manual (Page 43)

31362AC 43
End Point
Set the end point after the start point is defined. Pan the camera to another position
and press ENTER to save the position as the end point.
Direction
Use this to set the AUTOSCAN directions on the camera. The dome will start to pan
clockwise from the start point to the end point if your selection is RIGHT, and then
return to the start point. The dome will start to pan counter-clockwise from the start
point to the end point if your selection is LEFT.
Speed
Define the rotation speed while running Autoscan between 1 and 4 (10 to 45 degrees
per second).
Run Autoscan
After all settings related to Autoscan are configured, use this to execute the auto
scan.
Exit
Exit the AUTOSCAN setup menu. Go back to MAIN PAGE 2 to continue setting up
Pattern.
Note
You can execute the Autoscan function using the keyboard controller. Refer
to the keyboard user manual for more information.
LEFT
(counterclockwise)
RIGHT
(clockwise)
End Point
Dome Camera
RIGHT LEFT
Start Point