beautypg.com

Tour, Tour line, Tour point – OpenEye CM-512 User Manual

Page 41: Preset position, Speed, Dwell time

background image

31362AC

41

Tour

This function executes pre-positioning of the pan, tilt, zoom, and focus features in a
given tour for a camera. Before setting this function, you must define at least two
preset points.

Tour Line

There are eight sets of sequence lines built into the camera. Use the left or right
direction keys to select a line and then set the tour points.

Tour Point

Up to 64 points can be specified for each tour line. The tour points represent the order
of preset points that the dome will automatically run. The following setup items will
influence how the camera runs through each tour point.

Preset Position

Assign a specific preset position to the selected tour point.

Speed

Set the speed from one sequence point to the next. The speed can be set between 1
and 15. PAN speed ranges between 10 to 400 degrees per second, and TILT speed
ranges between 8 and 400 degrees per second.

Dwell Time

Set the duration of time that the camera will stay at a tour point, between 0 and 15
seconds. If this is set to 0, the camera will stay at this point until you manually move
the camera.

TOUR

TOUR LINE

1

TOUR POINT

01

PRESET POSITION

001

SPEED

01

DWELL TIME

001

RUN TOUR

ENTER

EXIT

YES