OpenEye CM-512 - Manual (Page 42)

42
Run Tour
Run the tour line manually.
Exit
Select the item to exit the TOUR menu and go back to MAIN PAGE 2 to carry on
setup of Autoscan.
Note You can execute the Tour function using the keyboard controller. Refer to
the keyboard user manual for more information.
Autoscan
Autoscan refers to the motion of scanning an area horizontally so that the camera can
catch a horizontal view. The parameters are listed as follows.
Autoscan Line
There are four sets of Autoscan lines built into the dome camera. Choose a line to
execute using the left or right direction keys. You can also command the camera to
pan endlessly by setting the start point the same as the end point.
Start Point
1. Move the cursor to START POINT and press ENTER while the item TO FIND is
flashing. The item will then turn to TO SAVE.
2. Move the camera to a desired position and press ENTER to save the position as
the start point. The cursor will move to END POINT automatically.
Note
The tilt and zoom values of the start point will be recorded and fixed for the
selected Auto-Pan line.
AUTOSCAN
AUTOSCAN LINE 1
START POINT TO FIND
END POINT TO FIND
DIRECTION RIGHT
SPEED 01
RUN AUTOSCAN ENTER
EXIT YES