Spanning tree / cist ports – Niveo Professional NGSME16T2H User Manual
Page 121
Chapter 3: Featuring Configuration
– Web UI
Featuring Configuration
– Web UI
NGSME16T2H User Manual | 121
Spanning Tree / CIST Ports
This page allows the user to inspect the current STP CIST port configurations, and
possibly change them as well.
This page contains settings for physical and aggregated ports.
The STP port settings relate to the currently selected stack unit, as reflected by the
page header.
Port
The switch port number of the logical STP port.
STP Enabled
Controls whether STP is enabled on this switch port.
Path Cost
Controls the path cost incurred by the port.
The Auto setting will set the path cost as appropriate by the physical link speed,
using the 802.1D recommended values.
Using the Specific setting, a user-defined value can be entered. The path cost is
used when establishing the active topology of the network. Lower path cost ports are
chosen as forwarding ports in favour of higher path cost ports. Valid values are in the
range 1 to 200000000.