Measurement Computing eZ-NDT version 6.0.9 - Manual (Page 8)

2-2 Investigation Mode Testing 938691 eZ-NDT
2. Set up the analyzer, hammer, microphone, and computer.
Connect your analog input signals to the analyzer (e.g., ZonicBook/618E, 640, or 650 device) BNC inputs.
Configure the analyzer as needed.
Reference Note:
If necessary, refer to your hardware user’s manual as applicable for information regarding:

Software Installation

System Requirements

Hardware Setup

Driver Installation
a. Connect the Impact Hammer to Channel 1.
b. Connect the Microphone to Channel 2.
c. Place the microphone within range of the output.
3. Launch eZ-NDT.
To run eZ-NDT, double-click the eZ-NDT icon or use your Windows desktop Start button to navigate to
the program file.
First Time Running eZ-NDT
Registration Form
Note: After you have completed the following steps, each succeeding time that you start eZ-NDT you will
be taken immediately to the main screen.
A registration form will open the first time you run eZ-NDT. You must complete the information in this
form to enable the eZ-NDT application.
The password accompanies your CD-ROM. You will not have to re-enter this information again, unless
you upgrade to a newer version, or have to re-install eZ-NDT.