Test all bad parts ……2-6, Test all “fail” (bad) parts – Measurement Computing eZ-NDT version 6.0.9 User Manual
Page 12
2-6 Investigation Mode Testing
938691
eZ-NDT
Autoscale of Initial Strike (Logarithmic Scale)
10.
Test all “Fail” (Bad) Parts.
Investigation Mode, Fail Part Template
To test all “Fail” (Bad) parts:
a) Select the “Fail” parts in the grid (see figure, upper right). Note that you can right-click on a part
number, e.g., “1” to access its associated template.
b) Strike the parts several times at a consistent location with a consistent amount of force.
c) If you do not see anything on your plot, click on the
button, to expand the y-axis.
This manual is related to the following products: