Gasboy CFN Series Site Controller III - Manual (Page 52)

Pump/Remote Dispenser Wiring Terminal Block ID
Page 48 MDE-4298D CFN Series Site Controller III Installation Manual · September 2009
Terminal Block ID
All mechanical pump/remote dispenser wiring for the CFN System is terminated in the PCU.
Terminal connectors should be used on the stranded wire when connecting to the pump power
and power input terminal blocks of the system. Connections made to the smaller screw
terminal blocks (Pump Control I/O Printed Circuit Board (PCB) Assembly) do not require
terminal connectors. The wire to these connectors must not be larger than 14 AWG. The
orientation of the chassis assembly is shown in
Figure 5-5 and Figure 5-6 on page 49 .
Figure 5-5: Pedestal or Wall-mount PCU - Terminal Block ID