Gasboy CFN Series Site Controller III - Manual (Page 22)

System Layout ICR2 (PA0398X0XXX0)
Page 18 MDE-4298D CFN Series Site Controller III Installation Manual · September 2009
ICR2 (PA0398X0XXX0)
Description
The ICR2 is a rugged and well-designed data entry terminal that gives users access to
self-service gas pumps. The unit is controlled by a microprocessor and communicates to the
site controller through Two-wire Current Loop communications.
The unit is available with an ABA Track 2 magnetic stripe card reader. A graphic liquid
crystal display is used to guide the user through the transaction. The display is backlit so that it
can be read at night. A membrane keypad and soft keys incorporate easy-to-read legends and
provide the user with the means to input data to the system.
The unit comes standard with a blank post. This post is used for mounting the ICR2 to the
island. The ICR2 is also available with a receipt printer post and/or a PCU mounted in the
post.
Communications to the ICR2 is through Two-wire Current Loop. If the ICR2 has a PCU in the
post option, both the Two-wire Current Loop and four-wire RS-485 wiring will need to be
installed between the Site Controller III and ICR2.
Location
The ICR2 should be located on the fuel island. The unit has been designed for an operating
temperature range of -40 °F to 104 °F with a relative humidity of 2% to 99% non-condensing.
Adequate clearance must be provided to allow easy access to the post’s access covers. An
ICR2 with a receipt printer or a pump control mounted in the post requires a minimum of
18” clearance between the post and any of the pumps or remote dispensers on the island.