Gasboy Gilbarco Interface Unit User Manual
Gilbarco interface unit installation manual
Table of contents
Document Outline
- Table of Contents
- 1 Introduction
- Caution
- Terms
- The Gilbarco interface unit
- Potential problems
- Cash/credit buttons and more than two price levels
- Many price levels on multiple hose units
- Measured totals for blended products not available
- Cash/credit select and Site Controller I
- Gallon cutoffs on multiple hose or fuel units
- Large gallon limits
- Product restriction on multiple hose or fuel units
- Volume display at Check Point or Profit Point
- Advantage version 70.1 firmware
- MPD-2
- MPD Pro Blender
- Modular MPD-3 version 53.7 firmware
- Multiple price levels on other Gilbarco pumps
- Incompatible pump firmware releases
- Loading Master Key
- Network Key Parity
- Contract Prices
- More than 16 CRINDs
- Blenders and Gascard Network
- Don’t leave GSM powered down
- Broadcast messages
- Grade restrictions with pre-Advantage MPDs
- Six-digit money on some pumps, five-digit on others
- 2 Installation
- What to do first
- Things to watch out for
- Starting up the site
- Site Controller configuration
- Program the Site Controller
- Program the dispensers and CRINDS
- Program the interface unit
- Connect and test the installation
- Troubleshooting
- If the system does not operate
- Transferring from Gilbarco console to Gasboy interface
- POS says PUMP BUSY on START key
- Receipt lines wrap
- Pumps work but prices won’t program correctly
- Interface suddenly begins giving unexpected results
- Messages on wrong CRIND or wrong pump activates
- Single pump won’t come up
- Site reports wrong fuel or wrong dollar amount
- MPDs will pump only zero-quantity transactions
- Zero quantity transaction
- Unassigned Transactions
- 3 Hardware
- 4 Data monitor
- Index