Gasboy Gilbarco Interface Unit - Manual (Page 20)

12 Installation Gilbarco Interface Unit v2.1
Gasboy CFN Series
real CRIND two-wire address is one smaller than the address reported by the CRIND
self-test).
• Step 3: add the result of step 1 to the result of step 2. The resulting total is the reader
number.
Price levels used at site
Circle the levels used. Only the prices to be used with Gilbarco pumps, and only levels 0 through
5, count here.
Price at level 0 is same as price
Circle Level 1 or Level 2 or Neither or Both according to the way the prices are set up at the site.
If you circle Neither you must determine whether your pumps will operate correctly in this
mode. Perform the procedure under Test for multiprice incompatibility, page 23. If any level 1
price differs from the corresponding level 0 price the two levels must be treated as having
different prices. Likewise for levels 0 and 2.
Price level for price bars
Price bars are the displays over the hoses, as distinct from the main price display. MPDs,
blenders, and so on may have price bars. Unless only one price is used at the site, all price bars
must show the same price level.
If you have no price bars on any pumps, circle None.
If levels 1 and 2 are always the same, circle 2 even if you have dual level price bars.
If levels 1 and 2 are different and you have dual level price bars, circle Both.
Other configuration information
There is some other configuration information that affects the setup of Gilbarco pumps and
CRINDs with Gasboy equipment.
Fuel grade assignment for each hose
Use Gilbarco fuel grade to indicate hose number to Gasboy equipment. Thus, any pump that has
only one grade on a side gets grade 1 regardless of which fuel it really pumps.
Pumps with more than one grade on a side have their grades numbered consecutively, from 1
to whatever number of hoses or grades are located on a side.
Some pumps, such as blenders and single-hose MPDs, have more than one grade per hose.
These pumps are treated by the Gasboy equipment as though they had one hose per grade. Thus,
a five-product blender looks to the Gasboy equipment like a five-hose MPD.
Assign a grade number to each hose. For each pump, list the hoses, with the fuels pumped
and the grade (hose) numbers assigned. You may use copies of the table on the following page.