Comtech EF Data XPA-200 - Manual (Page 71)

XPA200-7984-I-OPT1, X-Band SSPA Remote Control Remote Control
XPA200-7984-I-OPT1, Rev.2 5-19
XPA200-7984-I-OPT1 Remote Command Summary
Utility Commands Paragraph
Set Time 5.8.1.1
Set Date 5.8.1.2
Set Physical Address 5.8.1.3
Set Baud Rate 5.8.1.4
Set Parity Rate 5.8.1.5
Set LCD Contrast 5.8.1.6
Set LCD Brightness 5.8.1.7
Retrieve Equipment Type 5.8.1.8
Set Application ID Message 5.8.1.9
Configuration Commands Paragraph
Set Amplifier ON/OFF 5.8.2.1
Mute/Unmute 5.8.2.2
Set Attenuation 5.8.2.3
Select Auto Fault Recovery 5.8.2.4
Status Commands Paragraph
Retrieve Configuration Status 5.8.3.1
Retrieve Maintenance 5.8.3.2
Retrieve FET Status 5.8.3.3
Retrieve Utility Status 5.8.3.4
Retrieve Alarm Status 5.8.3.5
Summary Alarm Status 5.8.3.6
Terminal Status Change 5.8.3.7
Packed Configuration Status 5.8.3.8
Packed Maintenance Status 5.8.3.9
Packed FET Status 5.8.3.10
Packed Utility Status 5.8.3.11
Packed Alarm Status 5.8.3.12
Stored Alarm Commands Paragraph
Retrieve Total Stored Alarms 5.8.4.1
Clear All Stored Alarms 5.8.4.2
List All Stored Alarms 5.8.4.3