Comtech EF Data XPA-200 - Manual (Page 62)

XPA200-7984-I-OPT1, X-Band SSPA Remote Control Remote Control
XPA200-7984-I-OPT1, Rev.2 5-10
5.8.1.9 Equipment Type
Equipment Type is a command that retrieves the model number
and software version of the equipment. The information
cannot be changed by command.
Retrieve Equipment Type:
Confirmation: >DEV/RET_xxxxxxx yyyyy'cr''lf']
xxxxxxx = Model Number yyyyy = Software Version
Example: >DEV/RET_XPA200-7984-I SW_1.07
5.8.1.10 Application Identification
The Application Identification (AID) command allows a free
form message to be created. It is intended to identify either
the satellite, transponder, beam, destination or other aspects of
the application that may be significant to operations. The
message length corresponds to capability of the LCD and is 48
characters in total. The second line begins at character 25,
therefore, blanks must be used after line 1 information in order
to space to line 2. A carriage return ends the command.
Trailing blanks will be generated to fill the LCD field. The AID
display will alternate with the Equipment type display by use of
the clear function key on the front panel. The default is "AID
MESSAGE".
Application ID:
Confirmation: >DEV/AID_'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Retrieve ID:
Confirmation: >DEV/AID_'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Note: xxxxxxx ... xxxxx = Your message, maximum 48
characters.