Comtech EF Data XPA-200 - Manual (Page 14)

XPA200-7984-I-OPT1, X-Band SSPA Table of Contents
XPA200-7984-I, Rev.1 ii
Section Description Page No.
4 Redundant System Operation
4.1 General 4-1
5 Remote Control 5-1
5.1 General 5-1
5.2 Electrical Interface 5-1
5.2.1 RS-232C 5-1
5.2.2 RS-485 5-1
5.3 Physical Interface 5-1
5.3.1 Connector 5-2
5.3.2 Pin-Out 5-2
5.3.3 Cables 5-3
5.4 Protocol 5-4
5.4.1 Transmission Mode 5-4
5.4.2 Baud Rate 5-4
5.4.3 Format 5-4
5.4.4 Character Set 5-4
5.4.5 Response Timeout 5-5
5.4.6 Bus Inactivity Requirement 5-5
5.5 Access Methods 5-5
5.6 Addresses 5-5
5.6.1 Physical Address 5-5
5.7 Message Structure 5-6
5.7.1 Start Character 5-6
5.7.2 Device Address 5-6
5.7.3 Command 5-6
5.7.4 Confirmation Response 5-7
5.7.5 Error Response 5-7
5.7.6 End of Message 5-7
5.8 Command/Response Pairs 5-8
5.8.1 Utility Commands 5-8
5.8.2 Configuration Commands 5-11
5.8.4 Status Commands 5-12
5.8.5 Stored Alarm 5-17