Comtech EF Data turboIP-G2 - Manual (Page 90)

turboIP-G2 Performance Enhancement Proxy Revision 2
Management via the CLI or Web Server GUI CD-TURBOIP-G2
5–16
Typical for the SNMP v2 or SNMP v3 Configuration Wizard, continue as follows:
Would you like to enable SNMP?
• Press 1 or E to Enable SNMP
• Press 2 or D to Disable SNMP
You have almost finished the SNMP
Configuration Wizard. • Press 1 or S to Save SNMP Changes
• Press 2 or C to Cancel SNMP Changes
Once the SNMP Configuration Wizard closes, the appearance of the SNMP screen differs
depending on the SNMP for which the CLI has been configured.
5.2.3.4.2 SNMP Screen (SNMP v2)
The screen example shown here depicts the SNMP screen as defined by a typical SNMPv2 user.
Selection Entry Description
SNMP S Select as On/Off using ▲▼keys, press ENTER to save.
SYSTEM
INFORMATION
Name N As required.
Location L As required.
Contact C As required.
COMMUNITY
NAMES
Read-Write Access W SNMP SET Community String.
Read-Only Access O SNMP GET Community String.
Notification Access A SNMP Trap Community String.
Trap Destination IP Address T IP address destination for traps.
Run SNMP Configuration Wizard R
Select to erase and/or reconfigure all SNMP settings or to
change to the alternate SNMP Version (SNMP v2 or v3).