Comtech EF Data turboIP-G2 - Manual (Page 47)

turboIP-G2 Performance Enhancement Proxy Revision 2
Rear Panel Connectors CD-TURBOIP-G2
3–3
3.4 10/100/1000 BaseT Ethernet MGT Port (1X RJ-45)
Available on units manufactured from November 2010 forward, this port is a standard RJ-45
receptacle used for turboIP-G2 monitor and control (M&C) via Telnet, HTTP, and SNMP. It
can also used for updating turboIP-G2 firmware. This receptacle uses a UTP cable to connect
to an Ethernet hub, router, switch, PC, etc.
The connector pinouts are as follows:
Pin # Description Direction
1 TX+ Out
2 TX- Out
3 Rx+ In
4 N/A
5 N/A
6 Rx- In
For detailed information on M&C operations, see Chapter 5. MANAGEMENT VIA THE CLI
OR WEB SERVER GUI.
3.5 IEC Line Input (AC Power) Connector
A standard, detachable, non-locking, 3-prong power cord (IEC plug) supplies the
Alternating Current (AC) power to the turboIP-G2. Note from Figure 3-1 that the
orientation and location of the connector differs between the turboIP-G2 1/2-Width
and Full-Width units.
Note the following:
AC Power Specifications
Input Power 1/2-Width Unit: 100 to 240 VAC, 50 to 60 Hz, 90 W max
Full-Width Unit: 90 to 264 VAC, 47 to 63 Hz, 110 W max.
Input Voltage 100 to 240 VAC, +6/-10% - autosensing
(total absolute max. range is 90 to 254 VAC)
Connector Type IEC