Comtech EF Data turboIP-G2 - Manual (Page 10)

turboIP-G2 Performance Enhancement Proxy Revision 2
Table of Contents CD-TURBOIP-G2
viii
CHAPTER 8. FAIL TO WIRE ................................................................................... 8–1
8.1 Introduction ................................................................................................................... 8–1
8.2 Fail to Wire Board Operation ...................................................................................... 8–1
8.3 Fail to Wire Board Installed ........................................................................................ 8–2
APPENDIX A. SAMPLE CONFIGURATIONS ......................................................... A–1
A.1 Overview ....................................................................................................................... A–1
A.2 Point-to-Point Configuration ...................................................................................... A–2
A.3 Point-to-MultiPoint Configuration............................................................................. A–3
A.4 Hub-Spoke Configuration ........................................................................................... A–4
A.5 Dynamic Bandwidth Configuration ........................................................................... A–5
FIGURES
Figure 1-1. turboIP-G2 1/2-Width (top) and Full-Width 1RU Units (Chassis Only) ................ 1–1
Figure 1-2. turboIP-G2 Dimensional Envelope – Full-Width Chassis (Typical) ....................... 1–4
Figure 1-3. turboIP-G2 Dimensional Envelope – 1/2-Width Chassis (Single Unit Mount) ...... 1–5
Figure 1-4. turboIP-G2 Dimensional Envelope – 1/2-Width Chassis (Dual Unit Mount) ......... 1–6
Figure 1-5. turboIP-G2 Front Panels (Chassis Only) ................................................................. 1–7
Figure 1-6. turboIP-G2 Rear Panels (Chassis only) ................................................................... 1–8
Figure 2-1. Typical turboIP-G2 Full-Width and 1/2-Width Unit Rack Installations ................. 2–2
Figure 2-2. Full-Width Configuration – Universal Front Rack Bracket Installation .................. 2–3
Figure 2-3. PP-0000049 Rack Mount Kit ................................................................................... 2–4
Figure 2-4. 1/2-Width Rack Mount Kit Assembly – Single Unit Configuration........................ 2–5
Figure 2-5. 1/2-Width Rack Mount Kit Assembly – Dual Unit Configuration .......................... 2–7
Figure 2-6. Installation of Rack Mount Kit’s Bridge Clips / Docking the Units ........................ 2–7
Figure 2-7. Installation of Rack Mount Kit’s Chassis Link Rear Bracket .................................. 2–8
Figure 3-1. turboIP-G2 Rear Panels (Chassis only, prior to November 2010)........................... 3–1
Figure 3-2. turboIP-G2 Rear Panels (Chassis only, November 2010 and later) ......................... 3–1
Figure A-1. Point-to-Point Configuration .................................................................................. A–2
Figure A-2. Point-to-Multipoint Configuration ......................................................................... A–3
Figure A-3. Hub-Spoke Configuration ...................................................................................... A–4
Figure A-4. Dynamic Bandwidth Configuration ....................................................................... A–5