Comtech EF Data turboIP-G2 - Manual (Page 167)

turboIP-G2 Performance Enhancement Proxy Revision 2
Appendix A CD-TURBOIP-G2
A–3
A.3 Point-to-MultiPoint Configuration
Figure A-2. Point-to-Multipoint Configuration
In the Point-to-Multipoint configuration example shown in Figure A-2, a single turboIP-G2 is
used at the Hub to accelerate TCP traffic to three Remote sites, each with a turboIP-G2.
The following table defines the configuration settings for each turboIP-G2:
Configuration Parameter Hub turboIP-G2 Remote turboIP-G2 (1, 2, & 3)
WAN Transmission Rate 45 Mbps (equal to the TX data rate
of Hub modem)
2048 kbps (equal to the TX data rate
of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration No Selective Acceleration Rules are required. Rules could be added to
prioritize or set BW limits on types of traffic. Rules could also be added to set
a priority or BW limit on traffic to a particular site.
Route Table No Route Table entries are required. Routes could be added to allow remote
access from outside of LAN subnet.