Comtech EF Data turboIP-G2 - Manual (Page 80)

turboIP-G2 Performance Enhancement Proxy Revision 2
Management via the CLI or Web Server GUI CD-TURBOIP-G2
5–6
5.2.3.1 Configure Interfaces Screen
Selection Entry Description Section
easyConnect
[RO] Status only (always on) –
Management IP
Addresses M
• Add IPv4 or IPv6 Management IP Addresses
• Remove IPv4 or IPv6 Management IP Addresses
5.2.3.1.1
Web User Interface
W Select as On/Off using ▲▼keys, press ENTER to save.
–
SSH User Interface
S Select as On/Off using ▲▼keys, press ENTER to save.
–
Link Settings
L
Select/display LAN, WAN or Management Link Settings:
• Select using ▲▼keys, then press ENTER to set speed for each
port:
o
Auto-Negotiate, 10baseT, 10baseT-FD, 100baseTx,
100baseTx-FD , 1000baseTx-FD
• Displays the following [RO] information for each port:
o
MAC Address
o
Displays Link Status – Established, Not Established
o
Speed Reported
o
Auto-Negotiation – Enabled, Disabled
5.2.3.1.2
Advanced Options
A
• Select Interface mode as Single/Double using ▲▼keys, press
ENTER to save.
• Select Fail-to-Wire as Enabled/Disabled using ▲▼keys, press
ENTER to save.
5.2.3.1.3