Comtech EF Data turboIP-G2 - Manual (Page 110)

turboIP-G2 Performance Enhancement Proxy Revision 2
Management via the CLI or Web Server GUI CD-TURBOIP-G2
5–36
5.2.3.8.10 ‘snmp’ Command
The ‘snmp’ command allows the user to display the current SNMP configurations, run the SNMP
configuration wizard and enable or disable SNMP.
‘snmp’ Command Option Description
Print Displays the current SNMP configuration.
Config Runs the SNMP configuration wizard.
Disables or enables SNMP.
5.2.3.8.11 ‘stats’ Command
The ‘stats’ command allows the user to display both the Selective Acceleration and Optimization
statistics.
‘stats’ Command Option Description
Print
Usage:
ب stats print [-s|-o]
-s: Prints current Skipware statistics.
-o: Prints current Optimization statistics.
Clear
Usage:
ب stats clear [-s|-c|-o]
-s: Clear Skipware statistics.
-c: Clear just the Compression Ratio.
-o: Clear Optimization statistics.
5.2.3.8.12 ‘system’ Command
The ‘system’ command allows the user to control the unit functions, upgrade the unit, and save
and restore system configurations.
‘system’ Command Option Description
reboot
This command will reboot the unit. A confirm response after issuing this command
is required.
shutdown This command shuts the unit off.
restore This command restores factory defaults
upgrade
This command upgrades the unit using an FTP server.
Usage:
ب upgrade
save This command saves the current configuration of the unit.
reload
This command restores a configuration of the unit. The save command must be
used first in order to use this command.