6 ethernet ports, 1 ports, 2 lan port status leds – Comtech EF Data SDM-9600 User Manual
Page 71: 3 lan cables, Ethernet ports -9, Ports -9, Lan port status leds -9, Lan cables -9
Product Description
Memotec Inc.
5-9
5.6 Ethernet Ports
5.6.1
Ports
• 2 fully routed Ethernet IEEE 802.3 LAN interfaces
• RJ-45 10/100BaseT connectors
• Each port can be configured with 2 IP addresses
• Auto-detect speed, 10 or 100 Mbps
• Frame types: Ethernet II, IEEE 802.2, 802.3, SNAP
• Ethernet interface: Ethernet II and IEEE 802.2, 802.3
• Standards: IP RIP V1/V2 or Static, OSPF, NAT, IP Multicast IGMP V1/V2 PIM-
DM, BOOTP/DHCP Relay, DHCP client, IPX RIP and SAP, LLC2, 802.1p/q pri-
oritization and VLAN, 802.1D Spanning Tree Protocol (STP), MAC Layer
• Filter Criteria: Based on protocol, address (source, destination or SAP) or custom
filtering.
For information on connecting to the LAN hub, refer to
5.6.2
LAN Port Status LEDs
Two LAN status indicators are located above each Ethernet port on the SDM-9606 blade
(refer to
). These LEDs indicate the following:
•
LNK:
Indicates the LAN speed:
- Off: 10 Mbps
- Static green: 100 Mbps.
•
ACT:
Blinks (green) when there is activity on the corresponding LAN port (LAN
traffic transmitted or received).
5.6.3
LAN Cables
Each Ethernet LAN port has an RJ-45 female connector to attach a LAN cable. Select a
standard LAN cable with RJ-45 connectors at both ends.
NOTE:
Install a ferrite on each cable that connects to an Ethernet port: Steward ferrite
28A2029-0A0, Part No. 332-0003-000.