Comtech EF Data SDM-9600 - Manual (Page 45)

Hardware Installation
Memotec Inc. 4-7
b.
Press the top edge down until the module snaps into place between the
two metal clips at each end of the DSP socket.
NOTE:
When properly installed, the DSP module should lie flat in its socket, beneath
the two metal clips.
CAUTION: Do not force the DSP module into the DSP socket. If the DSP
module does not snap into place easily or sit properly in the socket, make
sure you have inserted it with the notched edge down.
9. Reinstall the SDM-9606 blade into the SDM-9600 chassis. Refer to the procedure on
“Installing a Blade” on page 4-9 .
Figure 4-4: Inserting a DSP Module – Final Position
DSP lies flat