Comtech EF Data SDM-9600 - Manual (Page 28)

SDM-9600 with SDM-9606 Blades Hardware Installation Guide
2-6 Memotec Inc.
2.2.3 Intent of Use and Network Compatibility
2.2.4 EN55022 and CISPR22 Warning
This is a Class A product that may cause radio interference. In this case, the user may be
required to take adequate measures.
2.2.5 FERRITES (EMI Filters)
To ensure compliance in the European Union with the standard EN 55024:1998 + A1 +
A2, Ferrites are required on each RJ48 cable connected to an E1 port and on each cable
connected to an Ethernet port.
Simply clamp the ferrite onto the cable, approximately 1 inch away from the connector on
the chassis.
Item Compatible Telecom Services
With SDM-9606 blade
100-1210-501
This telecom Equipment is intended to be connected to the
following telecom services:
• ISDN Primary rate access at 2048 kbps in all the countries
listed below
• G.703 Leased circuits at 2048 kbps structured and
unstructured, using 120 Ohm interface, in all the countries
listed below.
List of countries: Austria, Belgium, Bulgaria, Czech Republic,
Cyprus, Denmark, Estonia, Finland, France, Germany,
Greece, Hungary, Iceland, Republic of Ireland, Italy, Latvia,
Lithuania, Luxemburg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden,
Switzerland, UK.
Table 2-1: Compatible Telecom Services