Comtech EF Data SDM-9600 - Manual (Page 66)

SDM-9600 with SDM-9606 Blades Hardware Installation Guide
5-4 Memotec Inc.
5.4.1 Physical Dimensions
• Width (chassis only): 43.58 cm (17.16")
• Width (with brackets): 48.26 cm (19.0")
• Depth (chassis only): 38.55 cm (15.18")
• Depth (including power input shields): 41.42 cm (16.31")
• Height: 22.48 cm (8.72")
• Weight (chassis only): 12.7 kg (28 lb)
• Typical weight (fully loaded): 15 kg (33 lb).
5.4.2 Chassis System Status LEDs
A
POWER ON
LED is provided on the front panel of the SDM-9600 chassis. This LED is
located on the right side of the unit when viewed from the front. Refer to Figure 5-1 on
page 3 .
POWER ON
(green) goes on when the unit is powered on.
NOTE:
Other system status LEDs are located on the SDM-9606 blades (
OOS
,
ST
,
ALM
and
H/S
). See page 8 .
5.4.3 Power Input Modules
Dual power input modules are located at the rear of the SDM-9600 chassis (see Figure 5-
2 ):
• 2 redundant power input modules
• DC power connectors
• 1 power switch on each power input module (
1
=
ON
,
0
=
OFF
)
• Voltage: -48 VDC ± 5%, reverse polarity protected.
• Current: 6 Amps maximum
• SDM-9606 card maximum power consumption: 60 Watts.
NOTE:
A harness with 2 m. (approx. 6 feet) of triple wire is required to connect the
unit to the power source. Connection should be carried out by a qualified
technician only. Refer to
“Connecting to the Power Source” on page 4-15 for
instructions.