Comtech EF Data SDM-9600 - Manual (Page 40)

SDM-9600 with SDM-9606 Blades Hardware Installation Guide
4-2 Memotec Inc.
4.1 About the Hardware Installation
Hardware installation of the SDM-9600 involves the following steps:
• Installing the SDM-9600 chassis in a rack ( “Installing the SDM-9600 Chassis in
a Rack” on page 4-3 )
• Installing or upgrading a DSP module on the SDM-9606 blade ( “Installing or
Upgrading the DSP Modules” on page 4-4 )
• Hardware strapping on E1/T1 ports: Operation at 75 ohms ( “Strapping for E1-75
Operation” on page 4-8 )
• Installing a blade into the front of the SDM-9600 chassis ( “Installing a Blade” on
page 4-9 )
• Removing a blade ( “Removing a Blade” on page 4-12 )
• Installing the filler panels ( “Installing the Filler Panels” on page 4-14 )
• Powering up the unit ( “Powering Up the Unit” on page 4-15 )
• Connecting the console terminal ( “Connecting the Console Terminal” on page 4-
18 )
• Installing the licensed software options ( “Installing the Licensed Software
Options” on page 4-21 )
• (Optional) Connecting the unit to the LAN hub ( “Connecting the LAN Hub” on
page 4-22 )
In addition, the following maintenance procedure should be carried out on a regular basis:
• Cleaning the air filter in the SDM-9600 chassis ( “Cleaning the Air Filter” on
page 4-23 ).
Figure 4-1: The SDM-9600 Chassis Equipped with SDM-9606 Blades