Comtech EF Data SDM-9600 - Manual (Page 57)

Hardware Installation
Memotec Inc. 4-19
• Available console speeds are 1200, 2400, 4800, 9600, 19200, 28800, 38400,
57600 and 115200 bps. The equipment you connect to the console port must
operate at one of these speeds.
4.9.2 Activating the Console Connection
To activate the console connection:
1. Ensure that all SDM-9606 blades have successfully powered up with no system status
errors (see
“System Status on Power-up” on page 4-16 ).
2. Power the console terminal on or start your console terminal emulation program.
Take note of:
• “Important Console and Modem Settings for Startup” on page 4-18
• “Notice Concerning HyperTerminal Connections” on page 8-1 .
3. When you see the prompt
Type to connect
, press the key on the
console terminal keyboard several times, until the NetPerformer responds with a
prompt for the user login.
4. Enter the administrator login:
ADMIN
.
This is the default login. Additional user logins can be defined. For details, refer to
the chapter
Controlling Access to the NetPerformer in the Quick
Configuration fascicle of the NetPerformer System Reference .
5. Enter the password for this login. The default password for the administrator login is
SETUP
.
When the password is entered correctly, the SDM-9606 blade sends the product
banner to the console screen, as in this example:
LOGIN:ADMIN
PASSWORD:*****
ACCEPTED
SDM-9606 vx.x.x Memotec Technologies, Inc. (c) 2007
DSP QCxxx.BIZ code version: x.x.x
Console connected through TELNET
Voice transport method: PowerCell
Display commands, type HE
B3046082>
6. Enter the Display Alarms (
DA
) command at the NetPerformer console command line
to verify that your unit is problem free. In particular, look for any alarm messages that
indicate
Call Technical Support
.