Comtech EF Data SDM-9600 - Manual (Page 44)

SDM-9600 with SDM-9606 Blades Hardware Installation Guide
4-6 Memotec Inc.
a.
Locate the small metal clips that hold the DSP module into place at each
side of the DSP socket
b.
Push the clips apart with the tips of your fingers. The DSP module will
spring to an angle of about 45°.
5. Holding the DSP module by its edge, carefully lift it up and out of its socket.
Caution: Do not expose the DSP module or SDM-9606 blade to a mag-
netic field or electrostatic charge at any time. Damage to their components
could result.
6. Carefully remove the new DSP module from its protective packaging.
7. Hold the DSP module over the DSP socket at an angle of about 45° with its notched
edge down. Center the module over the socket.
8. Insert the DSP module into the DSP socket:
a.
First push the bottom edge of the DSP module all the way into the socket.
Use enough pressure to ensure that the DSP module is properly aligned
and fully inserted.
Figure 4-3: Inserting a DSP Module – Starting Position
45°
angle