Compuprint MDP40B Programmer Manual - Manual (Page 88)

A-86
ESC ?
Reassigns dot graphics mode. (EPSON ESC/P2)
ASCII Code ESC ? n m
Hexadecimal Value 1B 3F n m
Decimal Value
27 63 n m
Reassigns one of the dots graphics mode (described in the command ESC *) to one of
the following commands: ESC K, ESC L, ESC Y and ESC Z. The parameter n specifies
a character (K, L, Y or Z) which is reassigned to specific mode.
m = 0,1,2,3,4,6,32,33,38,39,40,64,65,70,71,72,73
m n
0 (K): ESC K graphic command
1 (L): ESC L graphic command
2 (Y): ESC Y graphic command
3 (Z): ESC Z graphic command
ESC [ g
High Resolution Graphics. (IBM Proprinter XL24/XL24E, 2391+, 9068)
ASCII Code ESC [ g n m data
Hexadecimal Value 1B 5B 67 n m data
Decimal Value 27 91 103 n m data
This command sends data for dot matrix graphics to the printer and allows the
selection of eight modes for both 8-wire graphics and 24-wire graphics.
n (count) Count is a two-byte value in the format of low byte, high byte that
gives the number of bytes of graphic data plus one.