Compuprint MDP40B Programmer Manual - Manual (Page 41)

A-39
pft Value Setting
01 Cut form
03 Cut form
11 Passbook with vertical fold
12 Passbook with horizontal fold
fc Defines the initial vertical offset.
fc Value Setting
0 6,1 mm (0.24 in.)
1 3,9 mm (0.15 in)
bw Used only if the REMS feature is installed
io If the fc parameter indicates that the position is to an offset print line, the io
byte indicates, if included, the number of lines to offset in hexadecimal.
According to the parameters set, the maximum accepted disalignment is determined.