BSS Audio Prosys PS-8810 Owner's Manual - Manual (Page 37)

- 37 -
PS-8810
DIGITAL SIGNAL PROCESSOR
Three-terminal removable barrier block connectors are provided
for audio output (Figure 6.5). Both main and AUX Audio Outputs
are balanced and can drive 1200 ohms or more to +20 dBu.
The two Main outputs and the eight AUX outputs allow the BSS
PS-8810 to act as a 24x10 matrix mixer. The sixteen Input
Processing Sections along with the eight CobraNet Inputs (PS-
8810C only) allow full mixing of any of the inputs to any of the
10 outputs.
Back Panel Output Connectors
Balanced output wiring is shown below. Notice that if the load is
connected to AC ground, the shield should not be connected to
the output ground terminal. This will prevent unwanted ground
loops.
Balanced Audio Output Connections
Connections Audio
About the Audio
Outputs
Balanced Output
Wiring