BSS Audio Prosys PS-8810 Owner's Manual - Manual (Page 100)

- 100 -
PS-8810
DIGITAL SIGNAL PROCESSOR
Each page contains 8 buttons. There are a total of 64 buttons (0-
These buttons correspond to the 64 different code # buttons on the
IQ Win control page. These buttons will only work if the IQ
address of the PS-8810 is set to 1.
Similarly, there are 64 buttons under the device IQ ADDR 2.
These buttons will only work if the IQ address of the PS-8810 is
set to 2.
To change the IQ address of the PS-8810 Pronto controls, open
the properties window up for each button. This is done by right
clicking on the button and selecting properties. The following
window will appear.
Under the 'Action' tab the RC5x command is displayed. In this
case it is "19 1 0", this command will select a PS-8810 device at
IQ Address 1 and send code#0. With this code highlighted, press
the delete button. Now a new code can be entered.
It is also possible to enter more than one command. In this case,
pressing the button on the remote will transmit multiple
commands for perhaps controlling multiple mixers or other IR
controllable equipment.
To enter a new code, click on the 'RC5/6' button. This allows
you to define a new RC5 or RC6 command. For the PS-8810, an
RC5x command is required.
Infrared Remote Control Philips Pronto