Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 9)

Getting Started 1-5
P r i n t i n g a C o n f i g u r a t i o n L a b e l
To print a configuration label, press the Test button on the back of the print server.
Use 6-inch long supply. If you are using supply that is shorter than six inches long,
temporarily change your Supply Type in the printer menu to “continuous” to print the
entire test label. After printing the test label, change your supply type to your previous
setting. Some information may print outside the label edges of narrow supply.
MonarchNet 2 Network Status
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Wireless Connected
00-33-22-AK-35-18 MAC
CZMO –7.01L
(2006.05.23)
Nwk Ver –
7.3 Boot Ver
Ver 5.1 WiFi Ver
1.0 Prn Ver
192.0.0.192 IP Address
255.255.0.0 Subnet Mask
192.0.0.192 IP Gateway
(via DHCP 192.0.10.192)
AUTO Boot Method
3 Boot Tries
0 min Timeout
1 min Keep Alive
ABC123 W iFi SSID
INFRASTRUCTURE W iFi Mode
11 W iFi Speed
Disabled W iFi W EP
72 Signal Strength
Actual SSID
Attached AP MAC
2485 Packets Received
225990 Bytes Received
448 Bad Packets Received
0 Receiver Overruns
193 Packets Transmitted
23731 Bytes Transmitted
At the printer, you can also print a network/wireless test label (third test label), which
lists the IP address, subnet mask, etc. See Chapter 5, “
Troubleshooting ,” for more
information.