Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 20)

2-10 MonarchNet2 Operating Instructions
Wireless Mode
The wireless mode sets how you communicate with your wireless network.
In Ad-Hoc mode, you do not need an access point. Ad-Hoc mode is also called peer-to-
peer (point-to-point) communications, so as long as the devices are in range, they will
connect and communicate with each other.
Infrastructure mode requires an access point to communicate.
Note:
If communicating in a mixed environment where both Ad-Hoc and infrastructure
mode are used, make sure the SSIDs are unique in both modes.
To change the setting, from the Setup Menu, select Network, then Wireless. Then follow
these steps.
1. Press  or  until you see Wireless Mode.
2. Press CHANGE to highlight Wireless Mode. The current setting is shown. Press
 or  to scroll through the options.
3. When you see the Wireless Mode setting you need, press SET to save the change.
Press CANCEL to leave it unchanged.
4. Press BACK until you return to the Home/Online screen.
WIRELESS
←Wireless Mode→
Infrastruct
WIRELESS
Wireless Mode
Ad Hoc →
SET CANCEL