Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 46)

4-2 MonarchNet2 Operating Instructions
A c c e s s i n g T e l n e t C o n s o l e M o d e
1. Start a Telnet session.
2. Type telnet 192.0.0.192 (your printer’s IP address) and press Enter.
3. You see “Welcome to MonarchNet2 Enter Password:”
Type access as the password and press Enter. (access is the default password.)
The password is case-sensitive. You may not be prompted for a username.
Note: The Telnet session times out after 10 minutes of inactivity.
4. To view the current wireless (or network) settings, type sh en (show wireless
settings) and press Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC123
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
5. To show the current IP settings, type sh ip (show TCP/IP settings) and press Enter.
IP is enabled
IP address 192.0.0.192 Boot tries 3
Subnet mask 255.255.0.0 Boot method AUTO
IP Gateway 192.1.1.192 Max window 10240
(via DHCP 192.2.2.192)
LPD banner disabled Timeout 0 min
LPD retries are disabled Keepalive 1 min
Service Port TCP port
PXR1E8580_X1 X1 9100
6. To change the SSID, type set en ssid testsystem and press Enter.
7. To set the IP address, type set ip ad 192.0.0.192 and press Enter.
8. To set the subnet mask, type set ip sub 255.255.0.0 and press Enter.
9. Type INIT and press Enter to save the settings and initialize the unit.
10. Type EXIT to exit Telnet.
See the following sections for a list of the most frequently used commands.