Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 58)

5-2 MonarchNet2 Operating Instructions
Use this table to solve some common printer/network problems.
Problem Action
Printer does not appear to save
IP, subnet, or gateway address. The value for each segment must be less than
255 in these addresses.
Printer does not communicate
with network card or access
point. If you have reset network or wireless settings,
allow time for the printer to reset and connect to
an access point. This may take a minute or
more, depending on network traffic.
The printer does not
communicate with your network. The network settings must match the print
server’s settings for:
 IP address, gateway, and subnet mask
 SSID
 Ad-Hoc or infrastructure mode
 Security
Cannot see print server on
network. The devices must be on the same logical
network and the subnet masks should be the
same.
Configuration/test label shows
“searching” or “set manually” for
boot method/DHCP. The message “searching” indicates the print
server has not connected to the network yet.
The message “set manually” indicates the boot
method is Static. If the boot method is not
Static, the print server was not able to connect
to the network.
Use this table to solve some common MonarchNet2 Web browser problems.
Problem Action
“Error sending the discovery
request” message on your
computer/Web browser. The print server is not communicating on the
network. Verify network and print server
settings, including IP address, etc.
MonarchNet2 does not appear to
be working. Turn off the printer and turn it back on. Print a
configuration label (press the test button on the
back of the print server) to confirm the IP
address, etc. Enter the correct IP address in
your Web browser.
“Authorization Failure” message
from MonarchNet2 on your
computer/Web browser. Enter the correct password when logging in to
MonarchNet2.